dc.contributor.author | Küçükömeroğlu, Tevfik | |
dc.contributor.author | Aktarer, Semih Mahmut | |
dc.contributor.author | İpekoğlu, Güven | |
dc.contributor.author | Cam, Gürel | |
dc.date.accessioned | 2020-12-19T19:41:05Z | |
dc.date.available | 2020-12-19T19:41:05Z | |
dc.date.issued | 2018 | |
dc.identifier.citation | Küçükömeroğlu, T., Aktarer, S.M., İpekoğlu, G., Cam, G. (2018). Mechanical properties of friction stir welded St 37 and St 44 steel joints. Materialpruefung/Materials Testing, 60 (12), pp. 1163-1170. https://doi.org/10.3139/120.111266 | en_US |
dc.identifier.issn | 0025-5300 | |
dc.identifier.uri | https://doi.org/10.3139/120.111266 | |
dc.identifier.uri | https://hdl.handle.net/11436/1718 | |
dc.description | Kucukomeroglu, Tevfik/0000-0002-4392-9966; Aktarer, Semih Mahmut/0000-0001-5650-7431 | en_US |
dc.description | WOS: 000451968400003 | en_US |
dc.description.abstract | In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely used in various industries. However, the joining of St 37 steel plates with higher strength grades such as St 44 grade steel is usually required when the strength of St 37 grade is not sufficient. Therefore, microstructural and mechanical properties of friction stir welded St 37-St 44 butt joints were investigated by conducting optical microscopy, microhardness measurements, and tensile testing. A fine-grained recrystallized microstructure was observed in the weld regions of the joints produced. the highest tensile strength, i. e. 385 MPa, was exhibited by the joint produced at 630 rev x min(-1). | en_US |
dc.language.iso | eng | en_US |
dc.publisher | Carl Hanser Verlag | en_US |
dc.rights | info:eu-repo/semantics/closedAccess | en_US |
dc.subject | Friction stir welding | en_US |
dc.subject | Dissimilar joint | en_US |
dc.subject | Steel St 37 and St 44 | en_US |
dc.subject | Microstructure | en_US |
dc.subject | Mechanical properties | en_US |
dc.title | Mechanical properties of friction stir welded St 37 and St 44 steel joints | en_US |
dc.type | article | en_US |
dc.contributor.department | RTEÜ, Teknik Bilimler Meslek Yüksekokulu, Motorlu Araçlar ve Ulaştırma Teknolojileri Bölümü | en_US |
dc.contributor.institutionauthor | Aktarer, Semih Mahmut | |
dc.identifier.doi | 10.3139/120.111266 | |
dc.identifier.volume | 60 | en_US |
dc.identifier.issue | 12 | en_US |
dc.identifier.startpage | 1163 | en_US |
dc.identifier.endpage | 1170 | en_US |
dc.relation.journal | Materials Testing | en_US |
dc.relation.publicationcategory | Makale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı | en_US |