Başlık için Enerji Sistemleri Mühendisliği Bölümü Koleksiyonu listeleme
Toplam kayıt 108, listelenen: 39-58
-
Fabrication and characterization of Au/n-ZnO/p-Si/Al sandwich device with Sol-gel spin coating method
(Springer, 2019)ZnO thin films with the n-type properties were obtained on the p-Si substrates for multi-layered sandwich device depositing by sol-gel method. Au and Al were conducted on two side of hetero-junction by PVD technique. From ... -
Fabrication of gold thin films on cooled glass substrates
(Springer, 2024)In this article, gold (Au) thin films were fabricated on glass substrates under vacuum conditions (4.5 x 10(-6) Torr) within a temperature range of 100-300 K, incrementing in steps of 50 K. Analyses through Field Emission ... -
Fault and sensor error diagnostic strategies for a vapor compression refrigeration system by using fuzzy inference systems and artificial neural network
(Elsevier Sci Ltd, 2015)A fuzzy inference system (FIS) and an artificial neural network (ANN) were used for diagnosis of the faults of a vapor compression refrigeration experimental setup. A separate EIS was developed for detection of sensor ... -
Fault diagnosis of a vapor compression refrigeration system with hermetic reciprocating compressor based on p-h diagram
(Elsevier Sci Ltd, 2014)The aim of this study is to show how to use the p-h diagram successfully for diagnosing faults in the vapor compression refrigeration cycle. This new approach is able to remove the gap between the information required to ... -
Hf2Co11 thin films: Rare-earth-free permanent nanomagnets
(Elsevier Science Sa, 2017)Hf2Co11 thin films were deposited on single crystalline Si(100) substrates by using conventional direct current (DC) magnetron sputtering with a Hf2Co11 alloy target. All films were grown at room temperature with 120W ... -
Hydrothermal gasification of Rosa Damascena residues: Gaseous and aqueous yields
(Elsevier, 2014)The gasification of Rosa Damascena residues - by-products of the rose-oil industry - was investigated under hydrothermal conditions at 500 degrees C and 600 degrees C, 35-45 MPa pressure with a reaction time of 1 h. the ... -
Improving the electrochemical energy storage capacity of the renewable carbon derived from industrial tea waste
(Springer, 2022)Energy storage is gaining a vital role since the usage of portable electric/electronic devices and vehicles have been growing. Capacitors, called as electrochemical double layer capacitors or supercapacitors, find application ... -
Improving the stability of solar cells using metal-organic frameworks
(Royal Soc Chemistry, 2016)Although Cu2S-containing chalcogenide solar cells are appealing and cost-effective for photovoltaics (PVs), these materials suffer from rapid performance degradation as a result of the diffusion of copper ions into the CdS ... -
Improving thermal resistance of lightweight concrete hollow bricks: A numerical optimisation research for a typical masonry unit
(Erol Kurt, 2020)Heat loss/gain through the walls accounts for about 30% of the total building energy losses. Bricks are indispensable parts of buildings as a very common masonry wall unit; hence the present work aims at optimising thermal ... -
Influence of downstream cross-sectional area ratio on flow boiling characteristics of expanding micro pin fin heat sinks
(Elsevier, 2023)In the present study, influence of downstream cross-sectional area ratio on flow boiling behavior of expanding micro-pin-fin heat sinks was experimentally studied. Three structured micro-pin-fin heat sinks, namely, Type1, ... -
Influence of film thickness and composition on the martensitic transformation in epitaxial Ni-Mn-Sn thin films
(Pergamon-Elsevier Science Ltd, 2015)Two series of epitaxial Ni-Mn-Sn thin films of different thickness are investigated for the thickness and composition dependence of the martensitic transformation. Thin films ranging in thickness from 20 to 200 nm (series ... -
Introducing the chemical potential of Cu-Mn-Al alloys for structural, electrical and thermal properties
(Springer, 2024)This study investigates the Martensite transition in Cu-Mn-Al alloys (CMAs) via the use of many methods, including scanning electron microscopy, temperature-dependent X-ray diffraction, resistivity and thermal measurements. ... -
Inverse magnetocaloric effect of epitaxial Ni-Mn-Sn thin films
(Amer Inst Physics, 2013)Epitaxial Ni-Mn-Sn thin films of 200 nm thickness were prepared by magnetron sputtering and deposited onto MgO(100) substrate. They reveal an inverse magnetocaloric effect with a martensitic phase transition around 260 K. ... -
Inverse magnetocaloric effect related to the magnetostructural phase transition in quaternary Ni-Co-Mn-Al alloy
(Springer, 2021)The inverse magnetocaloric effect of Ni-Co-Mn-Al quaternary alloy with the relatively low material cost is achieved firstly in a theoretical study (V. Sokolovskiy et al.: J. Appl. Phys., 2020, vol. 127, p. 163901). To ... -
Investigating the exergetic and environmental effects of subcooling and superheating processes on the performance of direct expansion systems
(Springer International Publishing, 2014)Recently, subcooling and superheating applications, which are proposed as an approach for the efficient use of energy, have positive effect on the emission next to increasing the energy efficiency. This study examines ... -
Investigation and mapping of natural and artificial radioactivity in sediment samples from Borcka Black Lake, Artvin-Turkey
(Taylor & Francis Ltd., 2022)All living creatures in nature are constantly exposed to ionising radiation, which is emitted from natural and artificial radiation sources. For this reason, it is important to monitor the levels of radioactivity in living ... -
Investigation of a hybrid solar and geothermal driven absorption cooling system for district applications
(Inderscience Enterprises Ltd, 2012)In this paper, a new hybrid geothermal and solar driven absorption cooling system (ACS) is proposed for low-temperature district energy applications. Two approaches are proposed in this study, namely: (a) a new model for ... -
Investigation of biogas and hydrogen production from waste water of milk-processing industry in Turkey
(Elsevier, 2012)This study is conducted to determine the potential for producing both biogas and hydrogen from a milk-processing waste water in Turkey. The results of this study indicate that a maximum of 54.2 million m 3 biogas/yr and ... -
Investigation of Cd1-xCoxS diluted magnetic semiconductor thin films fabricated by chemical bath deposition method
(Elsevier Science Sa, 2014)Chemical bath deposition method was used for preparation of Cd1-xCoxS thin films. the effects of Co doping and thermal annealing on structural, optical, electrical and magnetic properties of CdS thin films were investigated. ...